Kaba Saflok SAM RF - 2.3 Installing the SAM RF Software for Client;Remote Stations

To Next Page

To Previous Page

SAM

RF Operations Manual 13

Section 2: Installing the SAM RF System

2.3 Installing the SAM RF Software for Client/Remote Stations

Important: Do not connect the key encoder and utility device until all software is installed.

1. Before installing the SAM RF System software on a remote computer, you must complete the

following:

• Install the SAM application and database on the SAM RF server (the computer where you intend

to load the SAM RF database files).

• Share the SAMrf directory on the SAM RF server so remote users can link to the database. The

path to this directory on the SAM server is C:\Program Files\Samrf.

• Map a network drive on the remote computer to the SAM RF server’s SAMrf directory.

2. Insert the SAM RF System CD into your CD-ROM drive. The Security Access Manager Installation

program will launch automatically.

Note: If the Setup program does not auto-start, go to the Start menu and click Run. Click Browse to find

the setup.exe file located on the CD-ROM and double click it. Back at the Run PC dialog box, click OK.

3. Click Next at the Welcome PC dialog box.

4. Click Next at the Select Components PC dialog

box.

Important: DO NOT click the box next to “Install

SAM Database files.” Only “Install SAM Application

files” should be selected.