Kaba Saflok SAM RF - Resetting the Time;Date in Lock(S)

SAM
®
RF Operations Manual 156
Section 6: Locks
© SAFLOK WL 12/19/2007
6.5 Resetting the Date/Time in Lock(s)
It is important that your lock’s clock is set to the correct time. When the clock is set properly, the lock will
keep an accurate audit trail and allow entrance for keys with particular shift times, including Limited Use
keys. Each lock’s clock should be programmed yearly and after each battery change.
Note: Check that your computer’s clock is also set to the correct time.
1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet
and the USB cable between them is properly attached (see Section 2.5 “Installing the Key Encoder
and Utility Device”).
2. Click on the
Utilities menu at the
top of the window or the Utilities
icon.
3. Click on
Set the Time/Date in
Lock(s).
Note:
You must keep
all USB cables
connected between the
electronic key encoder base, the utility
device and the PC while the key image
spins on the PC screen.
4. The set date/time in lock(s) process will take a
few moments. When it is completed, a
message will appear indicating, “The write
operation was successful!” Click
OK.
5. Disconnect the USB cable located on the back left hand side of the electronic key encoder base. The
USB cable must remain attached to the top of the utility device. Remove the utility device with the
USB cable attached and take it to the lock(s).
The utility device screen will display, “Set
Date/Time.”
Utility Ver.
Set Date/Time