SAM
®
RF Operations Manual 162
Section 6: Locks
© SAFLOK WL 12/19/2007
Reloading Common Area Lock (continued)
5. The PC screen will display, “The write
operation was successful!” Click
OK.
6. The utility device screen will display, “Reload Common
Acc.”
7. Disconnect the USB cable located on the back left hand side of the electronic key encoder base. The
USB cable must remain attached to the top of the utility device. Remove the utility device with the
USB cable attached and take it to the lock.
8. Connect the USB cable on the utility device to the lock’s receptive port located underneath the bottom
of the lock. You will need to remove the rubber cover on the lock’s receptive port to insert the USB
cable. Be sure the connectors of the USB cable and the lock’s receptive port match up.
Utility Ver. 1.00
Reload Common Acc.
To Next Page
Loading...