SAM
®
RF Operations Manual 40
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Zone Information (continued)
4. In the Name field, highlight over ZONE 01 and type in an
appropriate name for your first zone, such as Building A or
Floor 01. Make sure that the Active box is checked, and
then click OK.
IMPORTANT: If you are using numbers, be sure to use only
two-digit numbers by including a 0 in front of any single-digit
numbers. For example, use Building 01 (not Building 1),
Building 02 (not Building 2), Building 10, etc. This will ensure
that the zones are listed in the proper order later in the site
design process.
5. Back at the Zone Configuration PC dialog box, the changes you just made to 1: ZONE 01 will appear
in boldface type. Continue entering zone information for your property by clicking on 2: ZONE 02,
etc., and then clicking Edit to display the Zone Edit PC dialog box.
6. When you have finished designating the appropriate number of zones for your property, click Save to
store the information in the SAM RF System.
To confirm that all zone information has been saved, go back to the Zone Configuration PC dialog
box. The names of the zones you just registered should no longer appear in boldface type.
To Next Page
Loading...