SAM
®
RF Operations Manual 47
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Unit Lock Information (continued)
3. Like the Suite Configuration PC dialog box, the Unit
Configuration PC dialog box will be empty. To add
units, click Add.
4. In the top field labeled Unit Name, type in the
designation for the first unit (e.g., Unit 101,
Building A, Unit 101, etc.) and click Add.
5. The unit you just named will appear in the list box
below the Unit Name field. You can continue
adding additional units in this manner, or you can
add a range of units to the system, as long as they
are all in the same zone and/or suite.
To add a range of units from the same zone into the system, type the word Unit or another appropriate
name (e.g., Building A, Unit 101, etc.), in the Unit Name box, then go to the Add Name Range area.
To add the numeric information BEFORE the information entered into the Unit Name box, click the open
circle in front of Prefix; to add the numeric information AFTER the information entered into the Unit Name
box, click the open circle in front of Postfix. Now enter the range of unit numbers, such as 101 to 999,
and click Add.
Note: If you are using numbers, be sure to use only two- or three-digit numbers by including a 0 in front of
any single- or double-digit numbers. For example, use 01 or 001 (not 1), 02 or 002 (not 2), or 10 or 010 (if
three digits are being used). This will ensure that the units are listed in the proper order later in the site
design process.
To Next Page
Loading...