SAM
®
RF Operations Manual 48
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Unit Lock Information (continued)
The units you just named will appear in the list box below the Unit Name field. If the information in the
box is not listed as you had intended, you can delete the entries individually by clicking on an entry and
clicking Remove. To delete all the entries at one time, click on the first entry, hold down the SHIFT key
and click on the last entry to highlight everything in the box. Click Remove and start over.
Once you have created the appropriate list of units, go
to the Zone for Units pull-down box to indicate in
which zone this unit (or range of units) is located.
Because you have already set up all the zones for your
property, the appropriate zone (such as Building A)
should already be in the pull-down box. Click on the
zone name. It will then appear in the field directly under
Zone for Units.
If the units are part of a suite, go to the Suite for Units
pull-down box to indicate which suite these units are in.
Because you have already set up all the suites for your
property, the appropriate suite (such as Building 1,
Suite A) should already be in the pull-down box. Click
the suite for these units. It will then appear in the field
under Suite for Units.
To Next Page
Loading...