SAM
®
RF Operations Manual 5
Section 1: Introduction
© SAFLOK WL 12/19/2007
1.3 SAM RF System Requirements
The SAM RF System is intended for use on a PC. System requirements include:
• Windows 98 SE, NT 4.0, 2000, XP, Vista, or Server 2003
• A minimum of Pentium II or greater PC processor, 64 MB RAM, 10-gigabyte hard drive, CD-ROM
drive, 3.5-inch floppy disk drive, and a V.90 internal or external modem
• At least one USB port for connecting the electronic key encoder device (a USB cable is provided)
• Anti-virus protection program (e.g., Norton AntiVirus, McAfee VirusScan)
• UPS and surge protection with an equipment warranty is suggested
• PC Anywhere Version 9.2 or greater for remote access or Virtual Private Network (VPN) access
(highly recommended)
Note: Due to the wide performance variability of hardware from different manufacturers, SAFLOK cannot
guarantee software compatibility with all computers. If you require a list of computers that SAFLOK has
tested and deemed software-compatible, please contact SAFLOK technical support at 800.999.6213.
To Next Page
Loading...