EasyManua.ls Logo

Kaba Saflok SAM RF - 1.4 Quick Reference Guide

Kaba Saflok SAM RF
193 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAM
®
RF Operations Manual 6
Section 1: Introduction
© SAFLOK WL 12/19/2007
1.4 Quick Reference Guide
Making New Resident Keys
1. At the main SAM RF screen, click Keys.
2. Click Create.
3. Click Resident Key.
4. Check New Key.
5. Select Unit Number.
6. Check the Key Expires box and set the expiration date. This is optional.
7. Click the button to the right of The Key Is Assigned To.
8. Select Resident and click OK.
9. Highlight the name of the resident and click Select.
10. Back at the Create Resident Key screen, check or uncheck the box next to the common access
lock(s) you wish to add or remove from the resident key.
11. Insert the key into the encoder.
12. Click OK. When the key is encoded the screen will display “The write operation was successful.”
13. Click OK and Cancel to return to the main screen.
Making Duplicate Resident Keys
1. At the main SAM RF screen, click Keys.
2. Click Create.
3. Click Resident Key.
4. Check Duplicate Key.
5. Select Unit Number.
6. Check the Key Expires box and set the expiration date. This is optional.
7. Click the button to the right of the Key Is Assigned To.
8. Select Resident and click OK.
9. Highlight the name of the resident and click Select.
10. Back at the Create Resident Key screen, check and uncheck the box next to the common access
locks you wish to add or remove from the Resident key.
11. Insert the key into the encoder.
12. Click OK. When the key is encoded, the screen will display “The write operation was successful.”
13. Click OK and Cancel to return to the main screen.
Invalidating a Lost Resident Key
1. Read each of the keys that were issued to the resident. This will provide the key’s ID and assigned
name.
2. Make an Inhibit Resident key for the key that was lost.
3. Use the Inhibit Resident key in the unit and all common access locks to invalidate the key that was
lost.
Reading Keys
1. At the main SAM RF screen, click Keys.
2. Insert the key into the encoder.
3. Click Read.
4. The Key Read screen will appear. When finished reviewing the information, click Close.

Table of Contents