5 Installation and Operating Conditions
5.1 Safety
➤ Strictly forbid fire, open flame and smoking.
➤ If welding is carried out on or near the machine, take adequate measures to prevent sparks or
heat from igniting oil vapours or parts of the machine.
➤ The machine is not explosion-proof:
Do not operate in areas in which specific requirements with regard to explosion protection are in
force.
For instance, the requirements of ATEX directive94/9/EC "Equipment and Protective Systems
intended for use in Potentially Explosive Atmospheres".
➤ Ensure that required ambient conditions are maintained with regard to:
■ ambient temperature and humidity,
■ clean inlet air with no damaging contaminants,
■ inlet air free of explosive or chemically unstable gases or vapours,
■ inlet air free of acid/alkaline forming substances, particularly ammonia, chlorine or hydrogen
sulphide.
➤ Keep suitable fire extinguishing agents ready for use.
5.2 Installation conditions
5.2.1 Determining location and clearances
The clearances given are recommended and ensure unhindered access to all machine parts.
➤ Please consult KAESER if you cannot comply with these recommendations.
Precondition The floor must be level, firm and capable of bearing the weight of the machine.
Fig. 11 Recommended machine placement and dimensions [mm]
A Exhaust fan
Z Air inlet aperture
5 Installation and Operating Conditions
5.1 Safety
No.: 9_9431_02 E
Service Manual 2-stage piston compressor
EPC
27
To Next Page
Loading...
Need help?
General
