KAIBO FLEX
Instructions
A n O p e n - e a r A u d i o E x p e r i e n c e
Headset x1
·Make sure your product comes with the following items:
(Please use a 5V 1 A charger for charging)
● Headset*1
Charging Dock*1
Pouch*1
Type-C charging cable*1
●
●
●
Charging Dock x1
Light sensor area
Type-C
Charging Port
Charging dock
LED indicator
Wireless
charging place
Headset LED indicator
Touch area
Type-C charging cable x1 Pouch x1
1 2 3 4 5 6 7
● Listening to music at high volume may damage your hearing and the
sound may be distorted.
● After storing for a long period of time, please recharge it before use.
Keep the charging dock dry before charging
Drying reduces the risk of damage to the headset
● Note that placing it in an environment that is too cold, too hot or too
humid may shorten the life of the battery.
Keeping the charging dock dry before charging reduces the risk of
damage to the headset
● Charging dock's charging voltage/current is 5V/1A.
The headset is splash-proof, but not completely waterproof. Please do not
immerse the earphones in water.
The new warnings that our company's products have obtained the NCC
low-power radio frequency equipment certification are as follows:
Low-power radio frequency equipment that has obtained an audit
certificate, not approved by the company, trade name or use
It is not allowed to change the frequency, increase the power or change
the features and functions of the original design without authorization.
The use of radio frequency equipment shall not affect flight safety and
interfere with legal communications;
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
OVERVIEW PRODUCT GETTING STARTED GUIDE QUICKLY SET UP YOUR KAIBO FLEX
Right (R) touch
Left touch(L)
Model: Kaibo Flex
Frequency response: 20Hz~20KHz
Bluetooth version: BT5.2 EDR
Headset battery capacity: 120mAh*2
Headset charging time: about 1 hour / supports fast charging
Bluetooth communication protocol: HSP, HFP, A2DP, AVRCP
Call: Support ENC call noise reduction
Headset waterproof rating: Ip55
Headset weight: 32g Charging dock weight: 29g
Headset usage time: 6-8 hours (average measured data at 70% volume)
Charging dock usage time: about 2.5 additional charges for the headset
Charging time in the charging dock: about 2 hours
Charging dock battery capacity: 500mAh
Bluetooth connection distance: > 10 meters
Speaker: Bone conduction speaker
Charging
Dock
Headset
Note: When the headset is fully charged, the headset light will turn off
" "
Both ear lights flashing quickly
One ear red and green light flashes slowly
The red light of the headset is on every 10 seconds
The red light of the headset is always on
Both ears are paring
The headset to be connected
The headset is in low battery
The headset is charging
The power of the charging
capability is < 33%
The power of the charging
capability is < 66%
The power of the charging
capability is < 99%
The charging capability is
100% charged
The first white LED light flashes slowly for
3 seconds/time
The first white LED is always on, the second
white LED light flashes slowly for 3 seconds/time
Three LED lights are always on
The first and second white LED lights are always on,
the third white LED light flashes slowly for 3 seconds/time
Restore factory settings
Music Mode
Call Mode
Volume+ Volume-
Previous Song
Answer/
hang Up Call
Voice Assistant
(when no music is playing)
Next Song
Mute
During Call
Unmute
During Call
Reject
The Call
Play/Pause Music
R/L X2 R X1 L X1 L R2s 2s
R/L X2 R/L X1 R/L X1 R/L X3
Long press 2 seconds
2s Click twice
X2
Click once
X1
Click 3 times
X3
R/L 2s
+ -
SMART TOUCH OPERATION INDICATOR DESCRIPTION STORAGE AND MAINTENANCE FCC WARNING
PRODUCT SPECIFICATION
Press and hold both sides for 10 seconds until you hear a sound. If
successful, red and green lights will flash alternately, the green
light will flash 3 times and automatically turn off.
BONE CONDUCTION BLUETOOTH HEADSET
To Next Page
Need help?
General