V User Manual Impulse Pedelec 7
1 Quick start
› 1. Charge the battery completely before riding for
the rst time.
› 2. Swivel the round charging socket cover on the
battery to one side.
Now insert the four-pole plug of the charger into
the battery charging socket.
Charging the battery
› 3. Insert the mains plug for the charger into the
socket.
You must lly charge the battery before using it for
the rst time.
› 4. Once all LEDs on the battery have gone out, pull
the charger plug out of the battery socket. Swivel
the cover back over the charging socket.
You can also remove the battery om your Pedelec
and charge it in the docking station. For more infor-
mation, refer to ➠ Chapter 4 "Charging the battery".
› 5. If you have charged the battery in the docking
station, reinsert the battery into the holder on the
Pedelec om the le-hand side. Tilt the battery
outwards at an angle of roughly 45° as you do so,
as you did when you took it out of the holder. Move
the battery into the upright position until the lock-
ing mechanism engages. If the key is still in the
lock, you will need to turn it clockwise and pull it
out as otherwise the battery will not lock in place.
› 6. Make sure that the battery is securely posi-
tioned and that the key is no longer in the lock.
› 7. Push the POWER button on the control panel on
the handlebar.
› 8. The display panel now displays the medium
power-assist mode SPORT. Press the arrow but-
tons to select the level of assistance: STAND BY
(o), ECO (low), SPORT (medium) or POWER (high).
Press this button once to change the level of assis-
tance by one level. This works both ways, depend-
ing on which arrow button you press.
You can ride o just as you would if you were riding a
normal bike. The motor provides assistance once the
rear wheel is turning.
› 9. You can now ride o.
To Next Page
Loading...
