What to do if I suspect an air leak in my Kampa Travel Pod Action AIR Camping Equipment?
If you suspect an air leak in your Kampa Camping Equipment, first, ensure that the inflation valve is properly screwed in and that the black ‘O’ ring seal is in place. Also, check that the top cap on the inflation valve is tightly secured.
Why is it difficult to pump up my Kampa Travel Pod Action AIR Camping Equipment awning?
If you're having difficulty pumping up your Kampa Camping Equipment awning, it might be due to the inflation valve not being fully screwed into the AirPole. Another potential issue is that the AirPole is twisted at the valve; if you hear a noise, stop inflating and untwist the AirPole.
General| Brand | Kampa |
|---|---|
| Model | Travel Pod Action AIR |
| Category | Camping Equipment |
| Language | English |
Warning about condensation and seam sealing for awning integrity.
Advice on awning suitability, touring use, and trial runs.
Attaching the awning tunnel to vehicle gutters using Keder beading.
Alternative method for attaching the awning tunnel without a vehicle gutter.
Using Velcro straps to attach the awning to vehicle roof bars.
Using optional pole and clamp kits for awning attachment to vehicle gutters.
Using Keder beading to connect the awning to a vehicle's roll-out awning.
Unrolling, pegging, unzipping doors, and inflating AirPoles for initial setup.
Securing inflation points, tightening caps, and pegging all points taut.
Attaching the canopy pole to the AirPole for specific models.
Attaching the groundsheet to the awning using 'O' rings.
Pegging guy lines to ensure proper tension without distorting the awning.
Details on included pegs and advice on pegging technique.
Information on factory taped seams and using seam sealant for waterproofing.
Awning suitability for weather, touring, and commercial use.
Explanation of condensation and its effects, referencing page 2.
Impact of sunlight on awning fabric and warranty exclusion.
Warning against using naked flames or cooking inside the awning.
Step-by-step guide to deflating the awning for packing.
Guidelines for storing the awning dry and appropriate cleaning methods.
Advice on zipper maintenance and recommended spares kit.
Steps to follow if an Air Pole is punctured and needs attention.
Instructions for removing, locating, and repairing Air Pole punctures.
Solutions for issues encountered during awning inflation.
Checks to perform if suspecting an air leak in the awning.
Diagnosing water leaks, distinguishing from condensation.
Addressing water leaks at specific seams or areas.
Step-by-step guide to setting up the optional AIR Annexe.
Instructions for attaching and setting up the optional front canopy.
Information about the optional two-berth inner tent accessory.
Details on the optional fleece carpet accessory for the awning.
Information on the SabreLink Flex lighting system for awnings.
Overview of the wide range of Kampa accessories available.
To Next Page
