1. Make sure the filter media is placed properly
inside the unit.
2. Be sure the cord is properly secured in the inlet
designed to hold the cord.
3. Place the lid that holds the reservoir securely to
cover the filter and pump compartment, making
sure all parts are connected properly.
4. Check the cap of the reservoir, it should be
screwed tight.
5. Be sure the K&H logo on the reservoir is facing
the water side of the bowl.
6. Place the CleanFlow on a level surface.
7. Clean the filter media regularly, at least once a
week, to ensure it is not being blocked by hair and
debris.
8. There may be an air lock in the tube. If water
flow does not start immediately, lift the front edge
of the bowl slightly to help release air from the
pump tube. This will help the pump grab water.
To Next Page
Loading...
Need help?
General