Made in China
K&H Manufacturing, LLC
Colorado Springs, CO
www.khmfg.com | (719) 591-6950
Outdoor Kitty House™ (Heated or Unheated)
Care & Instructions
Thank you for purchasing K&H Manufacturing’s Outdoor Kitty House™. When used correctly,
your Outdoor Kitty House™ should provide years of hassle free warmth for your pet. Your Outdoor
Kitty House™ is intended for use indoors and outdoors and is perfect for garages, porches
& barns. The Outdoor Kitty House™ is designed for use with animals only.
If you purchased the heated version - please pay special care to the instructions for the
included K&H patented heated pad located on the back.
PUTTING TOGETHER YOUR
Outdoor Kitty House™
a b
Locate the roof panel, the oor with 4 side panel
house structure, and the padded oor.
1
Zip both sides of the roof panel to the two side
walls of the house structure. See Figure 1.
2
Raise each end door panel to meet side panels and fasten securely with
hook and loop material sewn along edges. See Figure 2.
3
Locate the hook and loop material under end roof
panels and rmly attach to the tops of the door end
panels. Press rmly for good adhesion.
See Figure 4a.
5
Clear ap doors can be attached from the inside using
the hook and loop material. Adjust door to ensure free
swinging. Press rmly. See Figure 4b.
6
If you purchased the heated version, follow instructions on the back to
set-up your K&H heated pad.
Place the unheated or heated pad into the kitty shelter on the bottom panel of
the house structure prior to closing the second
door wall. Thread
the cord through
the cord hole.
See Figure 3a - 3c.
4
Cord hole is
located
in the crease
REV1_01-20-17
Figure 1
Figure 2
Figure 3
Figure 4
a b c
*If you purchased the heated version, follow instructions on the back for the K&H patented heated pad.
To Next Page
Need help?
General
