Kärcher BRC 30/15 C User Manual

– 8

Check high power cable, extension
cables and hoses for damage every
time before use.
 Check spray pattern of the nozzle.
몇 CAUTION
Risk of damage. Never use a wire or a
needle to clear plugged nozzles, but
rinse them with hot water (see "Trou-
bleshooting").
 Check hoses and seals to see if
there are damages. Have defective
parts replaced by Customer Ser-
vice.
 Check the brushes for wear, re-
place if required.
The brushes are considered worn,
if the bristles have the same length
as the yellow indicator bristles.
 Empty the fresh water tank and
waste water tank.
 Tilt the appliance backward and
store it on the pushing handle.
 Unscrew and remove the left and
right screws on the cleaning head.
 Remove the cleaning head.
1 Nozzle
2 Fastening clip
3 Hose clip
 Pull the fastener clip off to the side.
 Pull the nozzle backwards out of the
support plate.
 Open the hose clip and pull the noz-
zle off the hose.
 Insert the new nozzle into the hose.
 Assemble it back in the reverse se-
quence.
Note:
When inserting the nozzle into the sup-
port plate, watch for the correct aligne-
ment of the nozzle.
 Empty the fresh water tank and
waste water tank.
 Tilt the appliance backward and
store it on the pushing handle.
 Unscrew and remove the left and
right screws on the cleaning head.
 Remove the cleaning head.
Maintenance intervals
Daily before use
Every 25 operating hours
Maintenance Works
Replace the nozzle
Exchanging the brush
1
2
3
10 EN

Kärcher BRC 30/15 C Specifications

General

Brand	Kärcher
Model	BRC 30/15 C
Category	Floor Machine
Language	English