18
HDS 895
GB
4.7 Connecting the power
· See technical data, chap. 3 for connected
loads
· The voltage stated on the rating plate must
correspond to the voltage of the power source.
· The electric plug must only be fitted by an
authorized customer service/electrical
engineer. The direction of rotation of the engine
must also be observed. If the direction of
rotation is correct, there will be a powerful air
flow from the exhaust gas opening of the
burner.
· First, position the appliance switch to “STOP”
and then put the electric plug into the socket.
· If you are using an extension lead, it should
always be completely unwound from the cable
drum and have an adequate cross-section
(10 m = 1.5mm
2
, 30 m = 2.5 mm
2
).
4.8 Intended use
· Use the appliance to clean machines, vehicles,
buildings, tools, etc.
· Clean facades, patios, garden implements,
etc. with the high-pressure spray only, i.e.
without detergent. We recommend the dirt
blaster, a special accessory, for stubborn dirt.
· Engines must only be cleaned in places which
have appropriate oil traps (protection of the
environment).
· If the machine is used at petrol stations or in
other hazardous areas, the appropriate safety
regulations must be observed.
4. Start-up
To Next Page
