Kärcher K 4 - Recommended cleaning method; Interrupting operation; Finish operation

English 7
Î Turn the spray lance to "Mix" position - low
pressure.
Î Fill the detergent solution in the detergent
tank (observe dosage instructions on the
packaging of the detergent).
Î Adjust the suction volume of the detergent
solution by means of the dosage regulator
for detergents.
Turning the regulator to the left: Additional
dosage from the left detergent tank.
Turning regulator to the right: Additional
dosage from the right detergent tank.
Î Spray the detergent sparingly on the dry
surface and allow it to react, but not to dry.
Î Spray off loosened dirt with the high-pres-
sure ray.
Î Release the lever on the trigger gun.
Î Lock the lever on the trigger gun.
Î During longer breaks (more than 5 min-
utes), also turn the appliance off using the
"0/OFF" switch.
Î Insert the trigger gun in its holder.
Caution
Only separate the high-pressure hose from
the hand spray gun or the appliance while
there is no pressure in the system.
Î After working with detergent, suspend de-
tergent suction hose in a container filled
with clear water, switch the appliance on
for around 1 minute once the spray lance
has been removed and rinse until water
runs clear.
Î Release the lever on the trigger gun.
Î Turn off the appliance "0/OFF".
Î Turn off tap.
Î Detach the appliance from the water sup-
ply.
Î Press the lever on the trigger gun to re-
lease any remaining pressure in the sys-
tem.
Î Lock the lever on the trigger gun.
Î Pull out the mains plug.
Î Roll up the power cord and loop it e.g.
round the handle.
Î Insert the trigger gun in its holder.
Î Stow away the accessories in the acces-
sory holder.
Î Suspend the high-pressure hose into its
holder.
Î If detergent has been added: Suspend de-
tergent suction hose in a container filled
with clear water, switch the appliance on
for around 1 minute once the spray lance
has been removed and rinse until water
runs clear.
Î Release the lever on the trigger gun.
Î Switch the appliance switch to "0/OFF“.
Î Turn off tap.
Î Press the lever on the trigger gun to re-
lease any remaining pressure in the sys-
tem.
Î Disconnect the appliance from the water
supply.
Î Detach spray lance from the trigger gun.
Î Briefly switch the appliance on ("I/ON“),
press the trigger gun lever until no further
water is discharged (approx. 1 min).
Î Switch the appliance switch to "0/OFF“.
Î Use the safety catch to secure the trigger
gun lever.
Î Pull out the mains plug.
Î Store the power cord, the HP hose and the
accessories on the appliance.
Recommended cleaning method
Interrupting operation
Finish operation
Finish operation