6 English
Note: Always use Kärcher water filter (order no.
4.730-097.0) during suction operations of the
high-pressure cleaner.
Fasten the T-Racer to the high-pressure gun us-
ing the extension pipe.
Î Figure 2
1 Press the extension tube into the bayonet
connection of the high-pressure gun, then
turn by 90° until it locks into place.
2 Tighten the safety cover.
Repeat this process even for the other joints.
Î Figure 3
몇 Caution
Do not run over free-standing corners!
The T-Racer is not suited for scouring or
scrubbing!
Outdoor surfaces should be swept before
the T-Racer is used to avoid damaging the
high-pressure nozzles.
Fasten the T-Racer directly to the high-pressure
gun.
1 Press the bayonet connection of the T-Racer
into the connection of the high-pressure gun,
then turn by 90° until it locks into place.
2 Tighten the safety cover.
Î Figure 4
Caution
Always hold the high-pressure gun with both
the hands while cleaning the walls.
High-pressure cleaner does not build up the
pressure or is vibrating.
Î Dismantle the high-pressure nozzles, check
the high-pressure nozzles for damage, rinse
the T-Racer with clean water then reinstall
the high-pressure nozzles.
Î Figure 5
1 Remove the clip.
2 Pull out the high-pressure nozzle.
3 Rinse the high-pressure nozzle with clean
water, replace if necessary.
4 Insert the nozzle.
5 Re-insert the clip.
You can use the spray pipe extension with
any other Kärcher accessory.
Use a moist cloth and clean the appliance after
use.
The appliance is maintenance-free.
Only use original Kärcher spare parts. You will
find a list of spare parts at the end of this docu-
ment.
Application
Cleaning floor surfaces
Cleaning wall surfaces
Troubleshooting
Cleaning the high-pressure nozzle
General notes
Tip
Maintenance and care
Care
Maintenance
Spare Parts
To Next Page
Loading...
