– 7
Illustration
Unlock the holder of the filter bags and pull towards
the outside.
Illustration
Close the filter bag using the closing flap, remove
the filter bag and dispose it off.
Illustration
Push the new filter bag into the support until the
stop. First press the flap downwards; then push the
holder into the casing and lock it at the appliance
casing.
Motor protection filter: change before the last filter
bag is removed from the filter bag package.
The motor protection filter is behind the inserted fil-
ter bag. Change the motor protection filter before
you insert the filter bag.
Illustration
Unlock the frame and remove.
Remove the lower part of the frame, take out old
engine protection filter and dispose it off. Insert the
new engine protection filter in the frame and re-
place the lower part of the frame.
Illustration
Insert and click the frame into its place.
Order no. 6.414-805
Filter for pure blower air.
HEPA filter *: Change once a year.
Illustration
Open cover.
Unlock the HEPA filter and remove.
Illustration
Insert the new HEPA filter and click it into place.
Close the lid.
* EN1822:1998
Clean the reversible floor nozzle at reglular intervals!
Remove the nozzle from the suction pipe.
Illustration
Handle and suction tube can be disconnected in or-
der to clean or if clogged. Push the 2 interlocks and
pull apart.
Connect handle and suction tube and insert.
Subject to technical modifications!
Change the motor protection filter
Replace HEPA filter
Cleaning the floor nozzle
Cleaning the accessories
Technical specifications
Voltage 220 - 240 V
Current type 50/60 Hz
Mains fuse (slow-blow) 16 A
Protective class II
Weight (without accessories) 6,6 kg
Action radius 10 m
Dimensions ø 380 x
380
mm
Nominal width, accessories 35 mm
Sound pressure level (EN
60704-2-1)
57 dB(A)
Eco design as per 666/2013
Indicative annual energy con-
sumption
25,8 kWh/a
Rated power input 600 W
Dust intake on carpet 82 %
Dust intake on hard floor 104 %
Dust discharge 0 %
Sound pressure level L
WA
72 dB(A)
10 EN