10 English
ATTENTION
Operation with full container
When the container is full, the float
switch closes the suction opening and
the device runs at a higher speed.
Switch off the device immediately and
empty the container.
Note
If the device falls over, the float can al-
so close. To make sure the device
works absorbent again, set up the de-
vice, switch it off, wait 5 seconds and
then switch it on again.
Interrupting operation
1. Set the power switch to "0/OFF".
The device is switched off.
2. Option 1: Place the handle of the
suction hose in the intermediate
parking position.
Option
2: Hook the floor nozzle into
the parking position.
Finishing operation
1. Set the power switch to "0/OFF".
The device is switched off.
2. Pull out the plug.
3. Remove the device head.
4. Empty the container.
5. Storage option:
Note
The suction hose can be wrapped around
the device head and attached to the de-
vice head with the help of the hose collar.
6. Store the device in a dry and frost-
proof room.
To Next Page
Loading...
