Turn of the Century
TM
5
ASSEMBLY INSTRUCTIONS
1
1. Turn OFF the electrical power at the main fuse or circuit
breaker.
3
3. FLUSH MOUNT INSTALLATION (OPTIONAL)
a. Secure the canopy to the top of the motor adapter with
three ush mount screws from the hardware kit.
b. Hang the fan on the hook of the mounting bracket.
Proceed to Step 9.
2
Mounting
Bracket Screw
2. Remove the canopy from the mounting bracket by
removing the two mounting bracket screws from the oval
holes in the canopy. Then loosen the other two mounting
bracket screws from the L-shaped slots. Save the mounting
bracket screws for later. Install the mounting bracket
to the outlet box (not included) using the screws and
washers provided with the outlet box.
Warning: To reduce the risk of re electric shock,
or personal injury, mount to the outlet box marked
“acceptable for fan support” and use the mounting screws
and washers provided with the outlet box.
Flush Mount
Screw
Canopy
Hook
Mounting
Bracket
4. Loosen but don’t remove the set screws in the motor
adapter. Then remove the downrod pin and downrod clip
from the downrod.
Downrod Clip
Motor Adapter
Set Screw
Downrod
Pin
4
To Next Page
Loading...