Karma Ergo-Lite Series - Page 184

20
4.19 Pelvic Belt (Option)
4.19.1 Please follow the instruction to use the pelvic belt for your safety.
4.19.2 Please follow the instruction to assemble or disassemble the pelvic belt.
4.19.3 Put both ends of the pelvic belt straight through the backrest holder and
insert it through the buckle to adjust to the desired length. (Figure 4.45)
4.19.4 The most comfortable way of using the pelvic belt is to keep it as 45 degrees.
(Figure 4.47)
Figure 4.45
Figure 4.46
Figure 4.47
4.19.5 Please follow the instruction to adjust the pelvic belt.
4.19.6 Make sure that the total length of the pelvic belt is sufficient.
4.19.7 Adjust the length of the pelvic belt through the buckle of both ends. ( Figure
4.48)
4.19.8 Pull the two parts of belt tight. (Figure 4.49)
4.19.9 Push the buckle of both ends to the plastic clip so that the pelvic belt will
not slip out of the position. (Figure 4.50)
Figure 4.48
Figure 4.49
Figure 4.50
SUGGESTION:
● Please kindly be advised that the pelvic belt should be fitted tightly around
the pelvis and be tightened until you can just get one finger through
between the pelvic belt and the user. Kindly check the pelvic belt position is
fitted to the place as we recommend. If it is not able to be this way, please
consult your supplier.