LOCKING AND UNLOCKING THE VEHICLE
Press the button on the reverse of the key
fob and slide the key blade free.
Insert the blade into the lock located below
the passenger door handle. Turn the key
counter clockwise to open the door.
The vehicle's alarm will sound when the
door is opened. To switch off the alarm,
press the brake pedal and press the
Start/Stop button. If a recognized key fob is
detected, the alarm will be deactivated
and the vehicle will enter Drive mode.
Note: The alarm is also deactivated when
the vehicle enters Accessory mode (as long
as a valid key fob is recognized).
Note: If this fails to work, use the keyless
start backup procedure.
See “Keyless start
backup procedure” on page 74.
MANUAL DOOR OPENING
In the event of a power failure, each of the
doors can be manually opened from inside
the vehicle by pulling the release cable
located below the door handle.
To access the release cable, press the
lower edge of the cover below the door
handle and remove the cover.
To Next Page
Loading...