Need help?Do you have a question about the KAS crease matic 150 and is the answer not in the manual?
Details the programmable card creaser, speed, capacity, and material compatibility.
Covers power-on checks, setup, run, and edit modes.
Guides on setting up jobs, programming crease positions, and saving.
Explains how to feed sheets and use the crease head.
Details stopping motors, editing jobs, and restarting the feed motor.
Visual guide for programming a new job, including step-by-step instructions.
Instructions for adjusting the knife depth using lock nuts and the knife driver.
Procedures for adjusting the right and left hand side lays for crease accuracy.
Guidance on lubricating knife driver contact areas and cleaning feed rolls.
Diagrams showing perforating wheel positions in open and closed states.
Identification of the main components that make up the perforator unit.
To Next Page
General