Kask ZENITH - User Safety and Responsibility; Mandatory Knowledge and Risk Acceptance

2
DANGER! Intended use of this helmet involves activities that are extremely
dangerous. FAILURE TO READ AND FOLLOW THESE INSTRUCTIONS AND
ANY OF THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR EVEN
DEATH.
WARNING: Carefully read and understand these instructions. Use this helmet
exclusively for the activities provided by and in strict accordance with ANSI/ISEA
Z89.1:2014, and all applicable OSHA regulations. The helmet is Type 1 Class
E. This helmet meets the European Standard EN124292:2012 - Shock energy
absorption capacity - Clauses 4.2.1.2 (front), 4.2.1.3 (lateral), 4.2.1.4 (rear) and
the CSA Z94.1:2015 requirements (with the exception of clause 6.3 – protection
area) .
WARNING: Improper use of this helmet can cause serious or fatal injury. lf the
instructions are not followed correctly, the level of protection offered by the
helmet can be signicantly reduced. Inspect the helmet before each use far any
signs of visible damage. DO NOT USE HELMET IF THERE IS ANY SUSPICION
OF ITS CONDITION OR AFTER A MAJOR IMPACT.
WARNING: It is mandatory that the user becomes knowledgeable about all
features of the helmet, its capabilities and limitations, and gets specic
instructions and/or training from a competent and responsible person in the
proper use of the helmet.
WARNING: USERS OF THE HELMET ARE FULLY RESPONSIBLE FOR THEIR
ACTIONS AND ASSUME ALL RISKS FOR THEIR DECISIONS. KASK S.p.A.,
its afliates, subsidiaries, importers, distributors and dealers will accept no
responsibility in the event of an accident leading to injury or even death and
shall not be liable for any injury, death, loss, or damage resulting from improper
use of this helmet.
NOTE: Activities involving the use of this equipment are inherently dangerous.
You are responsible for your own actions and decisions. Before using this
equipment, you must:
- read and understand all instructions for use;
- get specic training in its proper use;
- become acquainted with its capabilities and limitations;
- understand and accept the risks involved.
Failure to heed any of these warnings may result in severe injury or death. The
manufacturer and/or distributor will accept no responsibility in the event of
accidents leading to injury or even death due to improper use of the helmet.
This helmet is constructed to absorb impact by partially distributing the shock
or by damaging its essential components. Wearing a helmet can reduce the
risk of head injury but cannot entirely eliminate it. This helmet should be used
US