Page
24
2
PLAYING THE PIANO
EQUALISER (EQ)
Equaliser allows the tonal character of the sound to be adjusted.
There are three equaliser modes available:
Equaliser type Description
EQ 1
Recommended for normal playing circumstances, such as in a
living room or classroom.
With headphones connected, the normal sound of the ES6 digital
piano is reproduced.
EQ 2
Recommended when the ES6 digital piano is facing a wall.
With headphones connected, the higher frequencies are
enhanced compared to EQ 1 or EQ 3.
EQ 3
Recommended when the ES6 digital piano is connected to
external speakers, or when recording.
With headphones connected, the normal sound of the ES6 digital
piano is reproduced (same as EQ 1).
Step 1
Press and hold the TOUCH and TRANSPOSE buttons, then press the REVERB button.
The LED indicators for the TOUCH, TRANSPOSE, and REVERB
buttons will start to flash, indicating that the EQ function has been
selected.
The name of the function ‘EQ’ (Equaliser) and the current settings will be
shown in the LED display.
Step 2
Press the
T
or
S
VALUE/BALANCE buttons to select the desired EQ mode.
Step 3
Press one of the TOUCH, TRANSPOSE, SOUND SELECTION, EFFECTS, or REVERB buttons to exit EQ
setting mode.
The LED indicators for the TOUCH, TRANSPOSE, and REVERB buttons will stop fl ashing.
EQ settings are global for all the internal sounds. It is not possible to have individual settings for each internal sound.
Any changes made to the EQ mode will remain until the power is turned off.
When the power is turned off, the EQ settings will return to the default setting of ‘EQ 1’, however it is possible to use
the Memory Backup function to store the preferred EQ mode. Please refer to the instructions on page 62 for more
information.
Mode 1 Mode 2 Mode 3
EQ
2
1
Press and hold both buttons
To Next Page
Loading...
Need help?
General
