KEB COMBIVERT F5 Series - Page 33

33
Value Function
Factory setting CP.31: 4
Factory setting CP.32: 27
Note: Enter-Parameter
*these functions are currently not supported by the F5G in the B housing.
Special Adjustments
36 Set value on AN3 > switching level {F5G only}
37 Timer 1 > switching level
38 Timer 2 > switching level
39 Reserved {F5M}
40 Hardware current limit active
41 Modulation on-signal
42 ANOUT3 PWM
43 ANOUT4 PWM {F5G only}
44 Inverter status (ru.0) = switching level
45 Power transistor temperature > switching level
46 Motor temperature > switching level
47 Ramp output > switching level
48 Phase current > switching level
49 Rotation forward
50 Rotation reverse
51 OL2 warning {F5G only}
52…58 Reserved {F5M}
59 Digital input (ru.22} "AND" > switching level {F5B only*}
60 Digital input (ru.22} "OR" > switching level {F5B only*}
61 Digital input (ru.22} "NAND" > switching level {F5B only*}
62 Digital input (ru.22} "NOR" > switching level {F5B only*}
63 Absolute value ANOUT1 > switching level {F5B only*}
64 Reserved {F5B only*}
65 Absolute speed on ANOUT1 > switching level {F5B only*}
66 Reserved {F5B only*}
67…69 Reserved {F5M}
70 Driver voltage aktiv ( safety relais)
71…72 Reserved {F5M}
73 Absolute value active power > switching level
74 active power > switching level
75…79 Reserved {F5M}
80 Active current > switching level
81 Real value channel 1 > switching level
82 Real value channel 2 > switching level
83 HSP5 bus synchronized
84 Reserved {F5M}