Need help?Do you have a question about the KegLand Icemaster G20.1 and is the answer not in the manual?
General| Pump Power | 60W |
|---|---|
| Glycol Tank Capacity | 20 L |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Material | Stainless Steel |
| Cooling Capacity | 2000W |
| Refrigerant | R290 |
Wait 24 hours after moving before powering on to prevent warranty void.
Ensure 100mm clearance for adequate airflow, preventing reduced performance and voided warranty.
Do not cool boiling wort; this can overload the compressor and void the warranty.
Never run pumps dry; ensure they are submerged during operation to prevent damage.
Steps to perform a leak test, check pump operation, and set temperature for the glycol chiller.
How to adjust the temperature controller on the G20 to the desired set point.
Table showing glycol volume, freezing point, and specific gravity for reservoir filling.
Steps to connect the G20 to a fermenter, including temperature probe placement and controller settings.
Instructions for using an external pump to cool distant fermenters effectively.
How to detach and attach temperature probes for the G20 controllers.
Steps to modify the target temperature for the glycol chiller.
Guide to adjusting advanced parameters like hysteresis, delays, and temperature limits.
Procedure for replacing old glycol solution with fresh, correctly concentrated glycol.
Instructions for connecting the G20 to an external heating device, requiring certified electrician.
To Next Page
