QuNeo Data Sources and Sensor Output
There are many useful types of sensors that can be found on the QuNeo:
Each sensor type has the ability to send out multiple MIDI messages at once for several
different kinds of sources.
Here is a list of exactly what kinds of sources are available in each of the sensor types:
Source Definitions
Note - Tapping on the sensor causes 1 note to output along with a velocity value relative
to how hard it is hit. Velocity sensitivity can be turned off if unwanted.
Pressure - Pressing on the sensor will cause the pressure CC# value to output from low
to high (soft to hard).
X-Axis (horizontal/side to side) - Pads only. Tilting a finger from side to side across the
surface of a pad will cause the X-Axis CC# value to output going from low to high (left to
right).
Y-Axis (vertical/top to bottom) - Pads only. Tilting a finger up and down across the
surface of a pad will cause the Y-Axis CC# value to output going from low to high (bottom
to top).
9
To Next Page
Loading...
Need help?
General