Keithley 2700 - Page 492

Current measurements (DCI and ACI) 3-17
AMPS fuse replacement (front panel
AMPS input)
3-19
Amps measurement procedure 3-18
Connections 3-17
Front panel inputs 3-17
Model 7700 switching module 3-18
CVI (C) examples H-2
D
Data flow D-7
dB 5-21
Commands 5-22
Configuration 5-21
Programming examples 5-23
Remote programming 5-22
Scanning 5-21
DCI and ACI connections
Using front panel inputs 3-17
Using Model 7700 switching module
3-18
DCV and ACV connections
Using front panel inputs 3-9
Using Model 7700 switching module
3-10
DCV input divider 10-3
Default settings 1-20, 1-22
Delay 7-8, 8-4
Auto 7-8
Auto delay settings 8-4
Manual 7-8
Ratio and channel average 5-19
Ratio/Chan Average 7-9
Setting 7-18
Timer Delay for STEP and SCAN 7-22
Device action 7-9, 8-5
Digital I/O 1-14, 8-7, 9-5
Digital input 9-5
Digital outputs 9-6
Commands 9-12
Logic sense 9-7
Master limit latch 9-7
Programming example 9-14
Pulse option 9-7
Remote programming 9-12
Scanning 9-12
Setting 9-10
Sink mode, controlling external devices
9-8
Digits 4-5
Commands 4-6
Programming examples 4-7
Remote programming 4-6
Scanning 4-6
Setting 4-7
Display 1-18
Annunciators 1-12
Commands 1-18
DISPlay:ENABle 1-19
DISPlay:TEXT:DATA 1-19
DISPlay:TEXT:STATe 1-19
Programming example 1-19
Remote programming 1-18
DMM measurements 1-27
Dual independent multiplexers 2-24
Dual multiplexer application 2-25
DUT test system 8-10
E
Error messages C-2
Examples
Basic measurement programming
examples
3-55
Buffer programming example 6-15
dB programming examples 5-23
Default and user setups programming
example
1-25
Digits programming examples 4-7
Display programming example 1-19
External triggering 8-10
Filter 4-16
Filter programming examples 4-22
Hold 8-6
Limits and digital outputs programming
example
9-14
Math programming examples 5-15
Multiple channel remote programming
example
2-21
Program and read register set
programming example
11-20
Range programming examples 4-5
Rate and bandwidth programming
examples
4-13
Ratio and channel average programming
examples
5-20
Read error queue 11-23
Rel programming examples 5-7
Scanning 7-33
Scanning programming example 7-32
Serial poll programming example 11-10
Set MSS (B6) when error occurs 11-9
Sytem channel remote programming
example
2-13
Triggering programming example 8-20
External triggering 8-7
Example 8-10