What to do if KELVIN HUGHES X-band Transceiver does not start up?
If your KELVIN HUGHES Transceiver isn't starting, the issue might stem from the power supply. First, check the relevant fuses and breakers. Then, inspect the power supply cable to ensure it's in good condition, with tight, corrosion-free connections. Finally, verify that the power source provides the correct voltage and sufficient current.
Why KELVIN HUGHES X-band Transceiver shows no data or scanner message?
If your KELVIN HUGHES Transceiver displays 'No Data' or 'No scanner message', it may be due to the radar scanner power supply. Ensure the scanner power supply cable is sound and all connections are secure and free from corrosion. Also, check the relevant fuses and breakers.
General| Brand | KELVIN HUGHES |
|---|---|
| Model | X-band |
| Category | Transceiver |
| Language | English |
Lists the tools required for installation and maintenance of the transceiver.
Details the components included in the installation fitting kit.
Important notices regarding water ingress and EMC performance.
Statement of compliance with R&TTE directive for radar scanners.
Guidance on selecting the optimal physical mounting location for the radar scanner.
Step-by-step instructions for securely mounting the transceiver unit.
Detailed procedure for correctly fitting the radar antenna to the pedestal.
Requirements and guidelines for installing the E70352 power supply unit.
Provides physical dimensions and mounting hole details for the transceiver.
Specifies minimum safe distances from magnetic compasses for equipment.
Outlines the standard cable and specific connections for the transceiver unit.
Guidelines for extending LAN cable length and proper joining techniques.
Details power supply connections, recommended cable lengths, and gauges.
Lists suitable ratings for circuit breakers and fuses for power protection.
Procedure for the first power-on test of the radar scanner system.
Steps to verify system functionality and antenna rotation after setup.
Instructions for checking and adjusting radar bearing alignment for accuracy.
Common problems, their causes, and solutions for system issues.
Guidelines for mounting and installing the optional AC/DC power supply unit.
Procedures for properly grounding the optional AC/DC power supply.
Details the terminal connections for the optional AC/DC power supply.
Technical specifications for the optional AC/DC power supply.
Explains how to operate the optional AC/DC power supply.
Information on maintenance, including fuse replacement for the power supply.
To Next Page