What to do if my Kemppi Protection Device ADF does not darken or flickers?
If the ADF (Auto-Darkening Filter) in your Kemppi Protection Device is not darkening or is flickering, the issue might be a soiled or damaged front cover lens, or the sensors could be dirty. Try changing the cover lens. If that doesn't work, clean the surface of the sensors.
Why is the vision poor with my Kemppi SA 35?
Poor vision with your Kemppi Protection Device may be due to a soiled protective lens or ADF. In this case, changing the lens is recommended. Also, ensure there is sufficient ambient light, as insufficient light can also cause poor vision.
How to fix slow response on Kemppi Protection Device?
A slow response in your Kemppi Protection Device could be due to a low operating temperature. Avoid using the device at temperatures below -5ºC (23ºF). Also, try increasing the sensitivity setting.
General| Brand | Kemppi |
|---|---|
| Model | SA 35 |
| Category | Protection Device |
| Language | English |
To Next Page
