X5 FastMig
Operating manual - EN
>> To take WiseFusion into use, go to the control panel's Welding parameters view and apply the WiseFusion fea-
ture.
>> To adjust the welding power/wire feed speed, in the control panel's Home view, turn the left control knob.
>> To fine tune the heat output while welding, in the control panel's Home view, turn the right control knob.
For more information on Wise products, visit www.kemppi.com.
3.4.3 WisePenetration+
Available with automatic 1-MIG-enabled equipment only.
In standard MIG/MAG welding, changes in stick-out length cause welding current to fluctuate. WisePenetration+ main-
tains constant welding current by controlling the wire feed speed according to the stick-out length. This ensures stable
and effective penetration and prevents burn through. WisePenetration+ also adjusts the voltage adaptively, which keeps
the arc focused and optimally short. WisePenetration+ enables welding with Reduced Gap Technolology (RGT) and is
compatible with 1-MIG welding process.
>> To take WisePenetration+ into use, go to the control panel's Welding parameters view and apply the WisePen-
etration+ feature.
>> To adjust the welding current while welding, in the control panel's Home view, turn the left control knob.
>> To fine tune the heat output while welding, in the control panel's Home view, turn the right control knob.
For more information on Wise products, visit www.kemppi.com.
3.4.4 WiseSteel
Available with automatic 1-MIG-enabled equipment only.
The WiseSteel function is based on modifying the conventional MIG/MAG arcs to enable higher quality of welds.
WiseSteel improves the arc control, reduces spatter and helps create an optimally-formed weld pool.
>> To take WiseSteel into use, go to the control panel's Welding parameters view and apply the WiseSteel feature.
>> To adjust the welding power/wire feed speed while welding, in the control panel's Home view, turn the left con-
trol knob.
>> To fine tune the heat output while welding, in the control panel's Home view, turn the right control knob.
When using WiseSteel, different adjustment methods are applied at different power ranges (different arcs). The wire
feed speed / current indicator shows the arc range: Short arc — Globular arc — Spray arc.
Short arc range:
© Kemppi
95
1920960 / 2144
To Next Page
Loading...
Need help?
General
