EasyManua.ls Logo

KEN STONE XN10-8 - Machine Safety Sign Identification; Hot Part Contact Warning; Lateral Angle and Track Caution; Incorrect Operation Bodily Injury Warning

KEN STONE XN10-8
174 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety
Safety Signs
1-38
6. This sign denotes not to touch any hot
part during operations or just after
operations. Do not touch before these parts,
including engine, pump, and exhaust pipe,
are cooled down.
7.
Caution
Maximum lateral angle at 10°
Take special cautions while driving over a
slope or during operations on rugged road. If
the lateral angle is >10°, the machine will
roll over. During the operations of machine,
always adjust the tracks to the outer
position. The inner position of the tracks is
only used for driving through narrow
passages.
8.
9.
10.
Warning
1. The operations or maintenance of this machine
by incorrect method will cause bodily injury
accident.
2. Before operating the machine, ensure to read
and understand the operation manual attached
in the machine.
3. Ensure that all safety facilities are ready and
effective.
4. Before operating the machine, please fasten
the seat belt.
Warning
If the machine is installed with an enlarged
bucket, the cab will probably be impacted
when the boom is at the maximum leftward
deflection position.
Caution
The hydraulic oil tank must contain a
certain pressure to prevent damaging the
water pump. Refer to the instructions on the
operation manual.

Table of Contents

Related product manuals