KEN STONE XN10-8 - Machine Operation Procedures; Traveling with Blade in Front; Traveling with Blade in Rear; Pivot Steering Operation

Operations
Operations of Machine
3. Retract the bucket and lower to 30~40cm
off the ground.
4. Lift the bulldozing blade.
5. Operate the traveling joystick as per
following procedure.
When the bulldozing blade is in the front of
cab:
To drive forward: Pull forward the joystick.
To drive backward: Pull backward the
joystick.
When the bulldozing blade is in the rear of cab:
To drive forward: Pull backward the
joystick.
To drive backward: Pull forward the
joystick.
3-10
Pivot Steering
Turn left when parking:
to turn forward left: push the right
traveling lever;
to turn back left: pull the right traveling
lever.
Turn right when parking, same operating
to operate the left traveling lever.