Daily routine checking (Every 10h)
Fulfill the following checking before the first
start of engine each day.
Warning
● Before operations, fulfill the daily
routine checking and when necessary
repair immediately.
● Before operations within the machine,
please securely fix the engine hood or
machine hood. Keep the engine hood
and machine hood closed under windy
weather or while parking the machine
on a slope.
Checking and adding of coolant
Warning
● Do not disassemble the radiator cap or
drainage plug when the coolant is hot.
Stop the engine, wait for the engine and
radiator to cool down, and then slowly
loosen and take out the radiator cap and
drainage plug.
● While handling the coolant (antifreeze),
ensure to wear goggles and gloves. In
event of splashing of coolant (antifreeze)
into your eyes or onto your skin, clean
by clean water immediately. Otherwise
it will cause injuries.
1. Open the engine hood.
2. Check the coolant level in the water tank
(1). The coolant level shall be within upper
limit and lower limit. If below the lower
limit, add coolant.
Adding
5-17
1. Take out the cap of water tank (1).
2. Add coolant, till the coolant level reaches
upper limit of water tank (1).
Upon detection of empty water tank (1)
during checking, check for presence of
water leakage and then check water level
of radiator (2). When necessary, add water
to the radiator (2) and then add water to
the water tank (1).
3. Install the cap (1).
Note: Add clean water (soft water) only to
compensate the lost coolant due to evaporation.
Add the coolant (antifreeze) and clean water
(soft water) of specified mixing ratio only to
Maintenance
Daily routine checking (Every 10h)
To Next Page
Loading...