CONVERSION INSTRUCTIONS
19
Natural Gas Hose Connection
1. Remove the LP gas hose and regulator using a wrench, and attach the natural gas
hose in it's place. (Fig. 40)
Adjust valve control screw
1. Pull all the knobs off of valve stems. Adjust
the screw in the valve hole using the flathead
screwdriver (C). Turn screws two complete
turns (720°) counterclockwise.
(Fig. 41)
2. Press all the knobs back onto valve stems.
After all the conversions are complete, return heat diffusers to firebox, followed by the grates
and warming rack.
Fig. 40
LP gas hose and regulator
NG Hose
Valve hole
Fig. 41
To Next Page