I. Hanghoodfrom(4)Mounting Screws. Slide hood
towards walt until mounting screws are engaged in
narrow end of (4) _. Tighten mounting screws
securely. A long screwdriver works best.
2. Replace bottom cover.
3. Connect ductwork to hood. Use Duct TaPe to make
joints secure and air tight.
4. Install (2) PAR20, 50 W Maximum Halogen Bulbs or
(2) R16, 40 W Maximum Incandescent Bulbs.
Purchase bulbs separately.
I See page 4 for Bulb information. I
Bulbs available by calling Sears at 1-800-4-MY-HOME _
I
,_ CAUTION: Bulbs may be hot! Refer to bulb
packaging for further information.
5. Replace filters, turn on power at service panel, and test
for proper operation.
KEYHOLE (4)
• : ii _
MOUNTING SCREW (4)
DUCT
TAPE
J_
PAR20,
50W MAX.
HALOGEN
BULB (2)
- or-
R16,
40W MAX.
INCANDESCENT
BULB (2)
2
O
::3
w
¢3
_h
To Next Page
Loading...
