It is recommended to clean the HEPA
media exhaust filter with cold water every
year.
NOTE:
When the cleaning of the filter
no longer restores vacuum cleaner suction
to full power, or the filter is worn or broken,
replace the exhaust filter. To purchase the
exhaust filter, call 1-844-202-9924.
1. Remove the exhaust filter cover by
pressing the release tab at the bottom of
the cover.
2. Remove the HEPA media exhaust filter
from vacuum cleaner.
3. Wash with cold water only, DO NOT
use detergent or soap. Allow to air dry.
Allow parts to dry 24 hours before
putting back into vacuum cleaner.
NOTE:
DO NOT operate without
exhaust filter installed.
DO NOT wash in the dishwasher.
DO NOT install the filter if damp.
4. Replace the HEPA media exhaust filter
into the vacuum cleaner.
5. Insert the exhaust filter cover tabs into
the upper slots and lock the filter cover
into place by pressing the lower part of
the cover until a click is heard.
- 19 -
HEPA MEDIA EXHAUST FILTER CLEANING
Ⅰ
Ⅰ
Ⅱ
Ⅱ
Release Tab
HEPA Media
Exhaust Filter
Slots
Tabs
To Next Page
Loading...
