Why does my Kennedy II Commercial heater shut off automatically?
The Kennedy Indoor Fireplace heater might shut off automatically because the room is too warm; it will turn off once the pre-set temperature is reached and will turn on automatically if the room temperature drops below the pre-set temperature. It can also happen if it is not secured properly to the appliance touch panel; after 10 to reset it.
What to do if my Kennedy II Commercial Indoor Fireplace remote control does not work?
If the remote control for your Kennedy Indoor Fireplace isn't working, the most likely cause is a low battery. Replace the batteries in the remote control.
What to do if no warm air coming out of Kennedy II Commercial Indoor Fireplace?
If no warm air is coming out of your Kennedy Indoor Fireplace, it could be because the room temperature is higher than the appliance setting (if it is set to room temperature); in this case, reset the temperature setting. Alternatively, the heater might be burnt out, so inspect the heater assembly and replace it if necessary.
How to fix light that is not glowing or dimming on Kennedy II Commercial Indoor Fireplace?
If the light on your Kennedy Indoor Fireplace is not glowing or is dimming, it could be due to a wire loosing. Also, inspect the Main circuit board because it may be burnt out or a wire loosing, and replace it if necessary.
General| Brand | Kennedy |
|---|---|
| Model | II Commercial Series |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
