Take care of the environment! Do not throw this device away
with other waste, but deliver it to the ocial collection point for
recycling.
Copying of this user manual for commercial purposes in prohibited.
Problem Solution
Code of your device’s manufacturer
is not on the list.
Use the 'Automatic code search'
method.
The device does not respond to
the commands of the universal
remote.
Try to enter every code from the
code list indicated for the brand of
your device.
Use the 'Automatic code search'
method.
Signals of the universal remote
cause the device to function
incorrectly.
The selected code may be wrong.
Try to enter another code from
the list next to the brand of your
device or use the 'Automatic code
search' method to nd the correct
code.
The device does not respond to
the commands of the remote, but
the indicator on the remote lights
up.
Press key TV on the remote.
Point the remote directly towards
the detection sensor of the
controllable device.
Operation distance of the remote
has decreased.
Replace the batteries with new
ones (size AA, 2 pieces).
The device does not respond to
the commands of the remote, the
indicator does not light up.
Replace the batteries with new
ones (size AA, 2 pieces).
In case the remote controller is
operated improperly, it’s possible
that it stops to work.
In this case, you need to take out
the batteries and reinstall them 20
minutes later, then the controller
will resume to the normal
application.
TROUBLESHOOTING*
You can download manuals of all Kenner remote control models with
full code lists in electronic form at www.digotv.eu
*If you have any further questions or queries about setup or operation
of the Kenner remote control, visit digotv.eu for the latest technical
information.
- 8 -
3301051
To Next Page
Loading...
Need help?
General