Kenton MIDI - Page 2

THESE KEY PRESSES ARE MADE ON THE CONNECTED MIDI KEYBOARD, not on the CS-50/60 itself
C Receive channel 1 [ Bottom C ] MIDI note number 36
Db " " 2
D " " 3
Eb " " 4
E " " 5
F " " 6
Gb " " 7
G " " 8 Selecting a receive channel
Ab " " 9 will automatically put the
A " " 10 MIDI into omni off mode.
Bb " " 11 That is, it will receive on
B " " 12 the selected channel only.
C " " 13
Db " " 14
D " " 15
Eb " " 16
E Omni on mode (default)
F Not Used - - -
Gb " "
G " "
Ab " "
A " "
Bb " "
B " "
C " "
Db " "
D " "
Eb " "
E " "
F " "
Gb " "
G " "
Ab " "
A " "
Bb " "
B " "
C " "
Db " "
D " "
Eb “ “
E " "
F p.bend & mod wheel OFF
Gb p.bend ON (default)
G mod wheel ON (default)
Ab controller Y ignored (see page 3 re controller Y)
A " vcf
Bb " *** (default) (*** = not used on this synth)
B controller X ignored (see page 3 re controller X)
C " vcf (default)
Db " ***
D MONO aftertouch ignored
Eb " modulation (default)
E " p.bend (up only)
F " vcf
Gb " ***
G velocity ignored (default)
Ab " vcf
A " vca
Bb MIDI volume ignored
B " vca (default)
C ENTER key Press and release. [ Top C ] MIDI note no. 96