Kenwood RV-7000 - Connecting Speaker Wires to Terminals; Screw Type Terminal Connection; Push Type Terminal Connection

English
19
Connections
How to connect the wire to terminals
How to connect the wire to terminals
(Screw type terminal)
(Screw type terminal)
1 Strip the vinyl coating of the wire by a length of
about 1 cm.
2 Loosen the knob.
3 Insert the wire.
Insert until the metallic conductor becomes invisible.
4 Tighten the knob.
How to connect the wire to terminals
How to connect the wire to terminals
(Push type terminal)
(Push type terminal)
1 Strip the vinyl coating of the wire by a length of
about 1 cm.
2 Push the lever.
3 Insert the wire.
Insert until the metallic conductor becomes invisible.
4 Release the lever.
B60-5827-08_00_En.indd 19 10.8.3 11:07:48 AM