Kenwood RV-7000 - Original Sound Playback Modes; Straight Decode and Pure Audio Modes; Switching and Canceling Special Modes

38
RV-7000/RV-6000/RA-5000
Playing music or movie
The display is turned off.
No video signal to the TV monitor.
(Except the HDMI video signal)
The illumination is turned off.
To cancel
Press [PURE AUDIO MODE].
STRAIGHT DECODE mode or PURE AUDIO MODE is also
canceled when [LISTEN MODE] or [VIRTUAL] is operated.
• If the input signal uses a number of channels larger than
the number of speakers in use, the signals are distributed
automatically according to the available speakers.
• The video other than the HDMI input video cannot be
monitored when PURE AUDIO MODE is selected.
STRAIGHT DECODE mode : The signal input from a source can be
output directly without any sound field effect added to it.
PURE AUDIO MODE : PURE AUDIO MODE turns the display
and analog video circuitry (other than HDMI) off to eliminate
their effects on the audio circuitry. This mode thereby makes it
possible to enjoy audio with higher quality and higher fidelity to
the original sound.
385($8',2
02'(
385($8',202'(
1 Select a source.
2 Start playback from the selected source.
3 Press [PURE AUDIO MODE] to select the mode.
Each press switches the mode as follows.
Mode Display
Straight decode mode "STRAIGHT" indicator is on.
Pure audio mode PURE AUDIO MODE indicator is on.
Off STRAIGHT and PURE AUDIO MODE indicators are off.
When STRAIGHT DECODE mode or PURE AUDIO MODE
is enabled, the listen mode is selected automatically
according to the input signal.
When PURE AUDIO MODE is enabled, the display is turned
off and the video signal other than the HDMI input is not
output to the TV monitor.
Monitoring the input source in the original sound (STRAIGHT
DECODE mode)(RV-7000/RV-6000 only)
Listening to music with PURE AUDIO MODE
PURE AUDIO MODE indicator
B60-5827-08_00_En.indd 38 10.8.3 11:08:16 AM