Kenwood TM-D700A Service Manual

Common section
TM-D700A/E
ADJUSTMENT
Measurement Adjustment
Item Condition Test- it | Terminal ; Specifications/
equipment Unit ermina Unit Parts | Method Remarks
1.Setting 1) Power voltage:13.8V
2) Band A, Band B
VOL, SQL knob:MIN
2.Reset
PARTIAL
OR
FULL
RESET?
1.
Press
[MNU]
to
enter
Menu
mode.
If
your
transceiver
seems
to
be
malfunctioning,
2.
Press
[@)/[$]
to
select
“RADIO
(1-)”,
then
initializing the transceiver may resolve the problem. press [OK].
Use
Full
Reset
to
initialize
all
settings
that
you
have
3.
Press
[@)/[W]
to
select
“AUX
(1-9-)",
then
customized. Partial (VFO) Reset does not initialize press [OK].
the
following
settings:
4.
Press
[4)[]
to
select
“RESET
(1-9-7)’,
then
Memory channels Memory channels names press [OK].
Memory channel lockout | Call channels
Program scan channels _|PM channels AUX 1-9-7
DTMF memory channel »>RESET
DTMF memory channels NO
names CpaAck ¢ + OK
Some of the VFO factory defaults are listed below: 5. Press [A V[# ] to select Partial (VFO) Reset, PM
Parameter Band A Band B Reset, or Full Reset, then press [OK].
440.000MHz * Aconfirmation message appears.
VFO freq. | 144.000MHz (U.S.A./Canada) | ¢ Press [ESC] to quit resetting.
0f430.000MH2 6. Press [OK].
Freq.
step
Canada)
or
12
skttz
|
25kH2
After
switching
the
power
OFF,
you
may
press
: [VFO] + POWER ON for Partial Reset, or [MR] +
Tone
freq._|
88.5Hz
88.5Hz
POWER
ON
for
Full
Reset.
This
allows
you
to
skip
steps 1 to 5.
You can also use the RESET button to perform
Partial or Full Reset.
Note : When in All-control Lock or Channel Display mode,
you cannot perform Partial Reset nor Full Reset.
@ COM connector
} o(eee99) 0 @® GPS jack
@) DATA connector
oO) @ PANEL connector
©) MIC connector
©) RESET button
Press momentarily to perform Partial Reset, or
press for 1 second or longer to perorm Full
Reset. No confirmation message appears. Use
this switch when the microcomputer and/or the
memory chip malfunction because of ambient
factors.
3.BPF Adjust 1) Band A SSG Rear panel] ANT TX-RX L204 To 1.8V or higher
FREQ.:146.050MHz:K | D.V.M TX-RX SMV L207 maximize
FREQ.:145.050MHz: L209 voltage
M4, E
SSG:5.01pV (-93dBm)
43

Kenwood TM-D700A Specifications

General

Brand	Kenwood
Model	TM-D700A
Category	Transceiver
Language	English