Kenwood triblade system pro HDM80

Questions and Answers

S
Susan CummingsJul 27, 2025
Why is there excessive splashing when using my Kenwood Kitchen Appliances hand blender?
- A
  Amanda SmithJul 27, 2025
  If you're experiencing excessive splashing with your Kenwood Kitchen Appliances hand blender, it might be due to a speed that's too high. Try selecting a lower speed initially and increase it as the mixture thickens. Also, ensure that you are using an appropriately sized container, as a bowl or pan that is too shallow or small can cause splashing. Make sure that you place the blades into the food before switching on.
F
floydjohnAug 1, 2025
What to do if my Kenwood Kitchen Appliances hand blender starts to slow down?
- T
  Timothy MurphyAug 1, 2025
  If your Kenwood Kitchen Appliances hand blender starts to slow down or labor during processing, it could be due to the speed being too low; try increasing the speed. Also, make sure you are not exceeding the recommended operating time. Do not operate the hand blender for longer than 50 seconds in any 4 minute period for heavy mixture or the whisk and frother/foaming tool for 3 minutes in any 10 minute period.
T
Tina AdamsAug 8, 2025
How to fix a Kenwood Kitchen Appliances hand blender that won't turn on?
- J
  Justin CarrollAug 8, 2025
  If your Kenwood Kitchen Appliances hand blender isn't working, first, check that it's properly plugged in. Also, ensure that all attachments are securely locked to the power handle.
S
Sherry VasquezAug 14, 2025
What to do if my Kenwood Kitchen Appliances hand blender is not blending?
- M
  Mike WoodAug 14, 2025
  If the mixture isn't blending properly with your Kenwood Kitchen Appliances hand blender, the speed might not be appropriate for the ingredients. Gradually increase the speed and blend until you achieve the desired result.
W
wschaeferAug 20, 2025
Why does the power handle of my Kenwood Kitchen Appliances get hot?
- H
  Heather SchneiderAug 20, 2025
  If the power handle of your Kenwood Kitchen Appliances hand blender gets hot during operation, the unit may have been used for an extended period. Allow the unit to cool fully before using it again.