Kenworth T470 - Table 7-1. Exhaust - SYSTEM CLEARANCE

Section 7
Routing
7-4
02/09

TABLE 7-1. Exhaust – System Clearance
Description Shielded Unshielded
Coolant hoses, HVAC hoses and tubing, and electrical wires
within 15” of the turbo and/or over 15” from the turbo 2” minimum 3” minimum
Fuel hoses
within 15” of the turbo
over 15” from the turbo
n/a
2” minimum
4” minimum
3” minimum
Fuel tanks and hydraulic tanks
crossing tank
parallel to tank
end of tank
aluminum/ceramic-coated exhaust pipe crossing tank
n/a
n/a
n/a
n/a
2” minimum
2” minimum
1” minimum
1.5” minimum
Air hose
nylon
wire braid
3” minimum
2” minimum
8” minimum
3” minimum
Exhaust system
(pipe, mufer)
Heatshield (or blanket)
Component
Shielded dimension
Unshielded dimension
FIGURE 7-5. Denition of measurements.
Heat shielding must not be directly mounted or applied to the Diesel Particulate

DPF resulting in equipment damage.
CAUTION: