TITLE:
NO.:
KEROTEST MODEL-1
REV.: 10
GATE VALVE
DATE: 7/12/07
OPERATIONS MANUAL
PAGE: 3 OF 35
This report is the property of Kerotest Manufacturing Corp. 5500 Second Avenue, Pittsburgh, PA 15207 and may not be
copied by any means without the expressed written consent of Kerotest. It is intended for the sole purpose of helping
Kerotest customers evaluate Kerotest products and may not be released to any third party or otherwise used in any
manner injurious to the interests of Kerotest.
INTRODUCTION
The Kerotest Model-1 design employs the following features. These include:
• Maintenance Free
• No Gland Tightening
• No Lubrication (during cycling)
• Low Operating Torque
• Directional Solidification Weld Ends
• Patented Packing – No Environmental Leakage
• Field Repairable
The intent of this manual is to acquaint our customers with installation procedures and repair
techniques for Model-1 Gate valves.
Kerotest stands ready to service our valves no matter where the location. Technical personnel
or our field representatives are ready to service you on very short notice.
To Next Page
Loading...