4. To lock the side supports, push out from
the inside until the support locks into
position (figure C.) CAUTION: Risk of
Unsafe Operation. Make sure all four legs
and both side supports are locked in place.
5. After locking the side supports in place, lift
the centre support section by the carrying
handle until you hear it “click” into place as
shown in figure D.
6. When the centre support section is
properly locked in position, the LOCK button
shown in figure E will be visible.
CAUTION: Risk of Unsafe Operation.
Make sure the centre support section is
locked in place.
CLOSING THE WORKBENCH
1. Fold the centre support section down and
push in on the side supports to unlock them.
(figure F)
3
To Next Page
Loading...