Keurig Hot Commercial Series User Manual

A. Setup Preparation
0
Remove adhesive tape and
LCD screen protection label.
Enlevez le ruban adhesif et
['etiquette de l'afficheur ACL.
Unwrap cord and plug into
grounded outlet.
Deballez le cordon et branchez
le systeme d'infusion dans une
prise mise a la terre.
WARNING: The Kl 50P brewer requires the use of an external water
filter such as the Omnipure KQB IPN 5572 1. available from Keurig Green
Mountain. Inc. Failure to use a filter invalidates the brewer warranty.
AVERTISSEMENT : Le systeme d'inlusion Kl 50P doit etre utilise avec un filtre
a eau externe comme le filtre Omnipure KQB IPN 55721 de Keurig Green
Mountain, Inc. La non-utilisation d'un filtre annule la garantie du systeme d'infusion.
Loosen the two mounting screws located on the upper
rear of the brewer and hang the KQ8 filter kit assembly.
Tighten the mounting screws [do not over tighten).
Devissez les deux vis de montage situees a l'arriere du
systeme d'infusion. en haut, et accrochez le filtre KQ8 .
Serrez les vis de montage !ne pas trop serrerl.

Keurig Hot Commercial Series Specifications

General

Compatible Pod Size	K-Cup Pods
Removable Drip Tray	Yes
Compatible Pods	K-Cup Pods
Brew Sizes	6 oz, 8 oz, 10 oz
Water Reservoir Capacity	90 oz
Brewing Time	Under 1 minute
Voltage	120V
Auto-Off	Yes

Summary

Important Safety Precautions

General Operating Safety

Covers basic safety rules for using electrical appliances, including handling and supervision.

Electrical Connection Safety

Focuses on proper outlet usage, grounding, and cord handling to prevent electrical hazards.

Appliance Usage Restrictions

SECTION 1 Setup & First Brew

Plumbing Fitting Connections

Connect the external water filter assembly to the water supply and flush the filter.

Setting Up Your Brewer

Remove packaging, plug in the brewer, and allow it to fill and heat the internal water tank.

Ready to Brew Your First Cup

Perform a cleansing brew, then prepare and brew the first K-Cup® pod.

SECTION 4 Troubleshooting

Brewer Power and Brewing Issues

Addresses common problems like no power, no brew, or partial cups with solutions.

LCD Screen Messages and Auto Functions